Re: Weighfeeder Modification Failed
A weigh belt feeder is it??
What was the original duty??
What is the new duty?? ■
Re: Weighfeeder Modification Failed
Dear designer
the weigh feeder is schenck fc0 421
the old duty is 5 t/h and it is increased to 20 t/h
any further information do you need ■
Re: Weighfeeder Modification Failed
I do not know this feeder, but I presume it is a weigh belt feeder.
So you have increased the capacity 4 times over the original. I presume you increased the motor power also by 4 times although you have not given this information.
But on any motor if the amps are too high then the motor is too small for the duty expected of it. ■
Weigh Feeder Problem
Dear Sir,
We are from Newton Weighing System Pvt Ltd, based at Kolkata. In case you want us to inspect your system and suggest solutions we can help you sort out the problem.
Thanks & regards
V.Sundar
Director-Technical
Newton Weighing System Pvt Ltd
64/1C, Bosepukur Road,
Kolkata- 700042
ph: 033 2442 9991
Mob: 09433039991
Email: newtonws@gmail.com ■
Weighfeeder Modification Failed
dear all
any one can help me in this problem
we made a modification in a weigh feeder of iron ore in cement plant to be as a slag weigh feeder by changing the motor by a bigger one and some parameters in the controller but we faced two problems
1- the current of the is very high and always tripped due to overload
2- very big error in the actual weight compared to the counted weight reached to 100 %
so if any one can suggest a causes for these problems
thanks ■