Replies
Re: Torsion Angle
Posted on
29. Jan. 2008 - 04:21
Your application is leading towards the good old Holzer Table for lineshaft analysis. Methods to develop the table can be found in most of the older mechanical design textbooks. ■
John Gateleyjohngateley@hotmail.comwww.the-credible-bulk.com
Torsion angle
Dear all,
I need clarification regarding torsion angle.
In text book torsion angle is explaining that one end is rigidly fixed another end is giving load.In this we can visualize theta
where as practical application motor coupled with line(transmitting lengthy shaft)shaft i cannot visualize theta becoz in this while transmitting load line shaft is properly supported at the ends& in between .Since rotatoinal free at both ends will it theta available?
Note:
our layout is shaft is coupled to one together in between load is
transmitted
No of shafts -25,shaft(one shaft) length-1m,In between torque is
transmitted if we used standard formula will that is accepted one? also more than 25 shaft are copuled together and it joining by rigid couplings can we take Length as total length?
Thanks for the replies
By
Prakash ■