Antworten
Re: Minimum Belt Speeds & Idler Diameters?
Erstellt am
5. Sep. 2012 - 04:06
I ask this question because I want to gain an idea of idler rotational speeds of conveyors in the lower speed spectrum.
That is:
Normal operation, not jog mode.
What is the lowest rpm's one would expect?
What industries primarily make use of these slow speed conveyors?
Thanks in anticipation! ■
Re: Minimum Belt Speeds & Idler Diameters?
Erstellt am
13. Sep. 2012 - 05:40
Is there anyone out there willing to offer some insight? ■
Re: Minimum Belt Speeds & Idler Diameters?
Erstellt am
13. Sep. 2012 - 12:44
What is the "question" (i.e. why are you asking this question)?
This may promote a / more informative response.
If I recall correctly the slowest I have physically seen (not designed) was ~50 mm / s (burnt and hence dusty Lime), with idlers ~100 mm at a spacing of ~250 mm.
If designing something, the designer would need to ensure it is suitable (applying the above may not achieve this).
Regards,
Lyle ■
Minimum Belt Speeds & Idler Diameters?
Hello All,
Could anyone help me with some general questions that I have for slow moving belt conveyors:
- What are the typical speed ranges and what scenarios will these be encountered? I.e. Slowest speeds to expect (quarries, sugar mills etc...???)
- What diameters are common for idler rolls that are used for these slow speed conveyors?
- Will these slow speed conveyors have a similar standard 3-roll carry, 1 flat return configuration spaced 1.5m, 3m respectively?
Any insight that you can provide will be greatly appreciated!
Regards,
Ryan ■