Perf Plate
get a hold of HENDRIX...on internet.........for punch plate, many many others who can supply same all over the place.
cheers. ■
Link
www.bearingchain.com/products.html
they sell HENDRIX punch plate.... ■
Re: Spray Drying Milk Powder
Originally Posted by George Baker
cheers.
how can we know what kind perforated plate we are using? i do not have any information about it. and it is difficult to measure.
Thanks you so much. ■
Remember Your Explosion Control System
Hello
I only wont to remember you to take care
that the explosion control system (by sure, suppression)
which protects the dryer to be destroyed by explosions
should be adapted in case you make important changes
just keep it in mind
regards
diego ■
Perf Plate Specs
well.....if you ordered it before, check the invoice for the specifications.
1. measure width x length edge to edge
2. find out alloy made of........for example T304, T316 stainless steel
3. count the holes per linear inch....may have to use a big MICROSCOPE TO ENLARGE ENOUGH to count the holes in the length of one inch
4. if you count, for example 150 holes.....in an inch....that would be 150 mesh
200 holes would be 200 mesh etc
5. mic the diameter of the wires or plate for thickness....
hope this is helpful........a lot of measuring...... ■
Spray Drying Milk Powder
perforated plate for directional air flow on spray drying milk powder
Dear Sir,
I'm looking for the perforated plate for directional air flow on spray drying milk powder
Pls send to us an offer.
I'm looking forward to hear from you soon.
Best regards,
Attachments
p1050791 (JPG)
p1050789 (JPG)
p1050786 (JPG)
■