Try to formulate comprehensive posts. You have asked elsewhere about using pipe conveyors. You also have several posts whining about your fines generation situation.

Forum experts are such because we have the knowledge & experience to solve problems. We are not mushrooms. If you don't give the full picture you can't expect much comment from the gallery. ■

DEAR MR NITISH

PLEASE NOTE PIPE CONVEYOR IS USED TO TRANSPORT MATERIAL FROM A MIN DISTANCE OF 60M AND NOT SUITABLE FOR THIS APPLICATION.

IN THE MEANTIME,PLEASE SEND THE DRAWING OF INCLINED CHUTE WITH CONNECTED EQUIPMENT DETAIL FOR SUGGESTING

A SUITABLE DEVICE.

THANKS

BALVINDER SINGH

CHIEF EXECUTIVE

M/S CML ENGG PRIJECTS P LTD

NEW DELHI-110014

MO-09899777763

E-MAIL:rajputeng@rediffmail.com ■

Dear Nitesh,

Give your detailed requirement to my personal id raghavan1973@gmail.com. I am working with an MNC dealing with pipe conveyors and i will revert back to you with solutions possible.

regards,

Raghavan ■

Mr. Nitesh,

As mentioned by Mr. Gateley, your information does not provide a basis for proper evaluation. I ask that you povide more complete information including:

1.) Material

a. Bulk density

b. Size distribution

c. Etc

2.) Max Rate requirements

3.) Profile data (in the for of a drawing)

4.) Etc.

From your description thus far, (to replace a transfer chute) you must need a lowering high angle system since your chute will not likely flow properly at angle less than 55 degrees.

Our DSI Snake Sandwich High-Angle conveyor system may be the best solution. Please visit our web site to learn more.

You can provide the required additional information, in this forum so that all experts can comment.

Joe Dos Santos ■

Dear Mr. Nitesh,

To reduce generation of fines you need to convey material with minimum relative motion between material and the conveying media. It is required to study your problem first before any conclusion. please let me know :

1. Flow of material ( average & maximum)

2. lay-out. desired feed & discharge of material in plan & elevation

& No of feed and dischage points

3. lay-out of the plant to know the space constraint.

I think, you are considering pipe conveyor as you want to avoid dust emmision in conveying alongwith minimising of dust generation. We manufacture pipe conveyor system. But its feasibility depends greatly on your lay-out.

We also manufacture completly enclosed troughed belt conveyorsystem and steep angle conveyor system which might solve your problem.

You can also mail me your data at fairtech@indiatimes.com

regades

Ketan Trivedi

FAIRTECH ENGINEERING CO. ■