The rods are stainless steel (I was told from manufacturer they use 304 Stainless steel for the rods)
This flanged immersion heatert was repaired in 1999. The buss bar was removed and replaced with a new buss bar. Four terminal pins were also removed and rewelded. The unit is in good operating condition as far as we know.
The unit is being sold as-is without any guarantee or warranty.
Additional photos can be sent upon request.
I will sell for any resonable offer.Buyer to pay shipping.
Used 100kw Immersion Heater w/ ss Rods
****SOLD *** SOLD **SOLD **SOLD
100 KW Flanged Immersion Heater
Manufacturer: Heat Exchange & Transfer, Inc.
Serial # J-5992 Model # FH1030-100-59S-483
RGA # 0722J5992-392
Believe unit was made in 1995
KW Rating 100KW VAC 480V
Hertz: 60HZ Phase 3 # of circuits: 3 Circuit Type WYE
Heater Amperage 120 HTR. AMPs/Circuit 48/36/36
Attachments: Bussing Diagram dwg 1030C3-A 10 inch flange, 30 rods, 150 lb flange
The rods are stainless steel (I was told from manufacturer they use 304 Stainless steel for the rods)
This flanged immersion heatert was repaired in 1999. The buss bar was removed and replaced with a new buss bar. Four terminal pins were also removed and rewelded. The unit is in good operating condition as far as we know.
The unit is being sold as-is without any guarantee or warranty.
Additional photos can be sent upon request.
I will sell for any resonable offer.Buyer to pay shipping.
Item can also be seen at
http://www.dallascontracting.com/ind...&op=read&id=13
if interested contact:
Dallas Contracting Co., Inc.
1260 New Market Avenue
South Plainfield, NJ 07080
Phone: (908) 668-0600
Fax: (908) 668-0601
website: http://www.dallascontracting.com
email: dkozul@dallascontracting.com ■