Re: Elevating Flyash Pneumatically Into Silo
Dear Mr Pankaj,
Your question is not specific enough.
You can use a standard pneumatic, road mobile, bulk tanker.
The compressor air displacement is then approx. 15 m3/sec and the conveying pressure is then approx. 1.8 bar (tank pressure is limited to maximum 2 bar)
The pipeline diameter is 6”.
The filter on th silo should be approx. 30 m2
Complete unloading time (including pressurizing the bulk tank) is then approx. 17 minutes
A smaller compressor requires a smaller pipe diameter.
However, if you are unloading a non pneumatic bulk trailer, using f.i. a rotary valve to feed the pneumatic conveying a lower pressure design should be applied.
In fact, a pneumatic design can be made for a variety of capacities, airflows and pressures.
What is your desired capacity?
More specific information will lead to a more specific response.
Have a nice day
Teus ■
Teus
Elevating Flyash Pneumatically into Silo
Dear Sir,
I am Pankaj from india and working in ACC Ltd (Holcim Group-Swiss).
I need a calculation sheet for conveying the bulk flyash Pneumatically into the flyash silo (26m height).
I want to know:-
1. How much air volume is required to convey 20MT into the 25m silo.
2. Pressure requirement
I will wait for your prompt reply.
Thanks
Pankaj Kumar ■