Replies
Re: Angle Of Internal Friction In Hoppers
Posted on
11. Sep. 2008 - 09:21
Jenike or walker (annular) shear cell are used to measure these values. ■
Mantoo
Re: Angle Of Internal Friction In Hoppers
Posted on
11. Sep. 2008 - 10:27
If you are just learning how to apply formulea then generic data can be found.
But you'd be extremely foolish to use this generic data for a real installation. ■
Powder Testing
Posted on
16. Sep. 2008 - 03:02
If you send me your email I will forward a short article - 'An introduction to the testing of powders for flow', that will answer someof your queries. www'lyn@ajax.co.uk ■
Angle of internal friction in Hoppers
Hi Friends
I am in learning process for design of hopper and belt feeders. When I was going through certain design materials I have, I came across certain terms like angle of internal friction, co-efficient of wall friction and wall friction angle.
My question is how these values are determined? Is there any table for these determined values for any given material?
Please give your opinions, advices or any similar references. ■