Re: Conversion Of Cement Mill To Raw Mill
HI,
It is possible to convert. But however a lot of inputs on the existing system is required. A few of them are listed below:
Length of the mill
L/D ratio of the mill
No of Compartments
Openings in the partition & discharge diaphragm
Capacity of the raw mill/Cement mill
Connected motor power
Is close circuit existing or needs to be close circuited.
And with regard to the layout,
How you propose to feed the material to mill.
How you propose to collect the product and convey to the Cement Storage silo.
These are a few basic things that need to be initially looked into. ■
Re: Conversion Of Cement Mill To Raw Mill
Hi,
We operate a converted cement finish mill as a raw mill. The center diaphragm screens were removed, and the separator (old Sturtevant) was fitted with a hot air furnace to dry the raw feed. No other major changes were made to the mill.
mikrno ■
Conversion of cement mill to raw mill
I would like to know following :
1. Can we convert cement mill (ball mill) to raw mill?
2. If yes, what are the factors to be consider for the same?
3. How griding media pattern is decided in ball mill? illustrate with example> ■